Madison | Honey Blonde Layered Synthetic Lace Front Wig

There are four simple steps to follow to wear your synthetic wig as a beginner for the most easy and natural look.

1. Tweeze off a little hair

If you like the thickness of your wig’s hair parting, it is fine to leave it as it is. However, it will look more natural and less “wiggy” if you carefully pluck some hair off the part and hairline. This will widen the gap in the part to look more realistic as well as give a natural gradated hairline look. We have easy to follow video tutorials on our YouTube Channel ‘UniWigs’ for how to tweeze your wig correctly.

2. Use a wig cap

Next, it is important to wear a wig cap before you wear your wig. A wig cap will even out your hair underneath and keep your wig clean. To use a wig cap, firstly tie your hair back. A good way to do this is to tie your hair into two braids, and then pin them to the back of your head; so your head is flat. Then put on your wig cap. Tuck all your hair in and leave no strands out.

3. Put on your wig

Bend over slightly to throw the wig over your head, securing the wig at the top and then the bottom. After the wig is on, push all the combs in. There are four combs in the synthetic wig cap: one on the top, two on the side and one on the bottom. Then, brush through the wig’s hair, starting from the bottom and working your way up. Never brush from top to bottom because that will force the knots down creating tangles.

4. Remove shininess

Synthetic wigs are unnaturally shinier than human hair wigs, which may give it away that it is a wig. But not to worry, this is easily solved! Simply use a dry shampoo to spray the synthetic wig all over. You can also shake baby powder or talcum powder over your wig. These methods will help to remove shine and give it a natural feel.

Firstly, put your wig onto a mannequin head. Clip or tie the hair back so that the lace will be easier to cut. Use a pair of scissors to begin cutting the front lace off. It is easier to cut little pieces off at a time. If you are a beginner, you may want to cut it slightly further away from the hairline in case you make any mistakes; you can go back and fix it. When cutting the lace, try and cut as close as possible to the hairline, without cutting any baby hair off.

Currently synthetic wigs cannot be bleached or dyed. Dyeing or bleaching a synthetic hair product could cause irreparable damage to the fibers, so we strongly discourage any dyeing or bleaching at this moment.

Yes. UniWigs heat-friendly synthetic wigs are made from heat-resistant fibers that allow you to curl, blow dry, flat iron and use hot rollers on your wigs.

While heat-friendly synthetic wigs can be heated, please note that they can only be heated to at 280F.

• Firstly, brush through the hair. Before you wash your synthetic wig, make sure it is detangled. Detangle any big knots with your fingers and then gently brush the hair by starting from the bottom and working your way up.
• Wash with mildly warm water. Really hot or really cold water will dry your wig out. Use mildly warm water to rinse your synthetic wig.
• Use a small amount of shampoo to make the water soapy, and then wash the hair in the water.
• After apply a conditioner to the hair. Rinse off with warm water.
• Hang up your wig to dry. After washing your wig, hang it up because you want the water to drip down. Leave the hair to dry overnight or all day.